Menu

Shop

Garage

Cart

Account

Products to Compare (max of 3)
X
Compare These Parts

How to Build Push-On Hose Ends

7/1/2016
Add Article To List
How to Build Push-On Hose Ends

Sounds simple enough, but doing this wrong can cause all number of issues down the road. Follow the steps below to ensure that you will have a solid, leak-proof connection for years to come.

Step One

Cut the hose evenly to the necessary length with a sharp knife. Put the fitting in a small bench vise (like the one in the picture) if you have one available, and oil the inside of the hose and outside of the fitting thoroughly.

Step Two

Push the oiled hose onto the fitting until the hose bottoms out under the protective sleeve. Clean the excess oil off and pressure test to twice the operating pressure to ensure a leak-proof seal.

Products Featured in this Article

Related Articles

How to Choose a Racing Harness
by Charles Aman - Posted in Tech
12/3/2021
Having a difficult time deciding which racing harness to use? With many options to consider from size to closure type, this article will walk you through how to go about choosing the perfect one for you and your race car. Safety first!
How to Choose a Racing Suit
by Mark Houlahan - Posted in Tech
11/12/2021
Your body dimensions, field of racing, and budget are all factors in picking the best racing suit for your needs. Our racing suit buyer's guide will help educate you on all aspects of racing suit features and benefits so you can make an informed decision.
How to Assemble Speedway Motors Aluminum Hot Rod Bomber Seat DIY Kit
by Joe McCollough - Posted in Videos
10/28/2021
How to assembly the new aluminum hot rod bomber seat DIY kit.
How to Install Side Detent Shifter for GM TH200, TH250, TH350, and TH400
by Joe McCollough - Posted in Videos
10/27/2021
Learn how to install a side detent shifter in a 1969 Chevy C10.
How To Crimp Spark Plug Wires and Install Boots
by Jason Lubken - Posted in Tech
10/22/2021
Learn how to install spark plug wire terminal ends. Our step by step guide takes you through terminal end and boot installation with the use of a wire crimping tool.
Selecting The Best Performance Spark Plug Wires
by Jason Lubken - Posted in Tech
10/13/2021
Learn about some of the differences between factory plug wires and the improvements you'll receive with a quality set of aftermarket performance wires in our spark plug wire buyer's guide
Murray Vintage Pedal Car Identification
by Speedway Tech Team - Posted in Tech
10/8/2021
Murray Ohio Manufacturing Company started producing pedal cars in the 1930’s. Here’s a guide on identifying Murray vintage pedal cars by body styles and various features.
Garton Vintage Pedal Car Identification
10/8/2021
For 95 years, Garton Toy Co. was the largest wheel goods toy factory in the world. Follow this guide on how to identify various Garton vintage pedal cars including the Kidillac and Tin Lizzy.
Installing ICT Billet LS Motor Mount Adapters
by Jordan Evans - Posted in Tech
10/6/2021
Jordan shows us how to use ICT Billet motor mount adapters to bolt a 6.0 LS into his 3rd-Gen Firebird.
How to Install a Billet LS Alternator Bracket
by Jordan Evans - Posted in Tech
10/6/2021
Follow this guide on installing a Speedway Motors Billet LS Alternator Bracket. If you’re looking for a simple solution that looks good while solving positioning issues from factory brackets, then these brackets are for you.
Error
X
Note
X
Ok