Project Chevelle Articles
Project Chevelle: 383 Part Two + Transmission Tech Article
We finally get to drive Project Chevelle after the big engine swap, and it's pretty awesome. Rowing through the gears with our new Tremec 5-speed isn't bad either!
Project Chevelle Episode 9: 383 Part Two + Transmission
Finally, Project Chevelle gets a real hot rod engine under its hood! And what about that flimsy old column shift three-speed? We've got that covered too.
Project Chevelle Episode 8: 383 Engine, Part 1
In this episode, Project Chevelle takes a big step in its muscle car transformation. It's out with the little old 307 and to the dyno with our new 383 from BluePrint Engines!
Project Chevelle 383 Engine Tech Article
At long last, Project Chevelle gets a muscle car heart transplant in the form of a 383 from BluePrint Engines.
Project Chevelle: Coilovers Tech Article
We add some tuneability to the suspension on Project Chevelle by bolting on QA1 coilovers front and rear.
Project Chevelle Episode 7: Coilovers
In this episode, Project Chevelle gets coilovers and a much-needed altitude adjustment. Watch as we install QA1 bolt-on coilover kits front and rear, then dial in the perfect stance and shock settings. Our old Chevelle is really starting to look mean!
Project Chevelle: Disc Brakes Tech Article
Project Chevelle upgrades the 4 drum brakes single master cylinder that was an unfortunate set of boxes checked on this Chevelle’s order sheet.
Project Chevelle Episode 6: Disc Brakes
After getting the control arms and drop spindles installed last time, we are dying to see what it looks like on the ground. Today we are working with the Speedway Deluxe Disc Brake Kit. Josh and Joe are on a roll!
Project Chevelle Episode 5: Spindles and Control Arms
We install Speedway's tubular upper and lower control arms and G-Comp spindles to make Project Chevelle look and corner far better than stock.
Project Chevelle: Spindles and Control Arms Tech Article
Project Chevelle undergoes front suspension upgrades to minimize feeling every dip and bump in the road. Josh S. walks through the install and quick overview of the tubular control arms and G comp spindles.