Products to Compare (max of 3)
X
Compare These Parts
Talk to the Experts. Call 800.979.0122, 7am-10pm, everyday.
Since 1952
in
in
Talk to the Experts. Call 800.979.0122
Shop By
Support
Account
Street Race Truck More... The Toolbox

Differential Identification and Axle Measurement

9/19/2016

Here are a couple helpful diagrams to for when it comes time to work on that rear end in your classic. The first is a simple measurement illustration, so you don't wind up ordering an axle that is two inches too long, or even worse, too short. To look over our selection of differential housings, Click Here.

Ford 9 Inch Rear End Identification

There are several different variations of the 9 inch Ford housing in use today! Use the image below to find out what style of housing you have, as this information will come in handy if you decide to order a big brake kit from our selection. To browse Speedway Motors' various Disc Brake Upgrade Kits available, Click Here!

Products Featured in this Article

Related Articles

U-Joint Selection and Design
by Speedway Tech Team - Posted in Tech
9/28/2020
Designing a steering system for your street rod can be tricky. In this article, we'll show you how to choose the right U-joints and steering shaft for the job.
Choosing Parts for Your Ford 9" Third Member Build
by Speedway Tech Team - Posted in Tech
6/11/2018
Lucas P. explains how to choose the correct part for a Ford 9" third member build in order to achieve a bulletproof rear. You will find specific recommended parts to use from Speedway Motors.
GM 10-Bolt Polished Finned Aluminum Rear End Cover Installation Guide
by Steve Lewis - Posted in Tech
12/19/2017
Steve provides a step-by-step guide to install the Speedway Motors GM 10-Bolt Polished Finned Aluminum Rear End Cover.
Speedway Tech Talk - Ford Banjo Rear End Open Drive Conversion Kit
by Tim Matthews - Posted in Videos
6/28/2016
Tim talks about our Ford banjo rear end open drive conversion kit.
Model A I Beam Front Axle Install
by Speedway Tech Team - Posted in Tech
3/6/2018
Our hot rod expert takes you through his ford I beam axle setup. Follow as he sets up the front end on his split wishbone front suspension Model A.
Suspension Front Solid Axle Design
by Jason Lubken - Posted in Tech
9/15/2016
We will show you the differences among traditional I-beam and tube axles and suspension designs used on hot rods; the differences between cross and traditional steering, measuring for springs, what spindles to choose, and much more.
8 Inch to 9 Inch Upgrade
by John Wulbern - Posted in Tech
9/15/2016
In this Tech Tip, John responds to a customer looking to upgrade the 8” stock differential in his Cougar to a 9” open diff.
EMi Micro Sprint 3-spoke Hubs
by Frank Galusha - Posted in Videos
9/7/2017
Eagle Motorsports shows off their premier 3-spoke Micro Hubs.
Speedway Tech Talk - Early Ford Hubs & Bearing Components
by Tim Matthews - Posted in Videos
8/9/2016
Tim talks about soem of the early Ford hubs & bearing components we offer.
How to Install a Hydraulic Throwout Bearing
by Speedway Tech Team - Posted in Tech
10/8/2020
One of the most challenging things about swapping transmissions can be figuring out the clutch linkage. Speedway can show you how to install the upgraded hydraulic throwout bearing with ease.
Error
X
Note
X
Ok