1966 Studebaker Commander Parking Brake Assemblies

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

Jeff converts his 1967 Chevelle manual brake system to power by installing a Delco booster kit. Learn how to make the master cylinder more resistant to brake fluid and a few tips for an easy install.

Check out the 410 sprint car brake installation and bleeding the brakes! We're making serious progress on our build.

Learn about the steps and tools necessary for a smooth chassis assembly for your sprint car.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

In this Tech Tip, John makes a few suggestions for a customer looking to update the braking system on his ’51 Deluxe.

See how Jeff tackles the installation of a 9" power brake booster on his '67 Chevelle. Learn some tips for this application and why it's important to leave some free travel at the top of the pedal swing.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.