Jaguar Dana 60 Driveline and Axles

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

The Speedway Motors Tech Team created a quick how-to on squaring the front axle of your open wheel race car.

Learn how to assemble the front axle of a sprint car. See what tools are needed for assembly including an angle finder gauge tool and king pin reamer.

Drag racing changed a lot in the 60's, and Dick Landy was right in the middle of it all. This 64 Dodge was the first factory built 426 Hemi car to win a sanctioned drag race. How cool is that?

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Jennifer Helgoth is a painter and prolific builder who has amassed an fleet of Cadillacs, including this '60 Series 62 with one amazing paint job.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Check out this headlight wiring and taillight wiring diagram.

In this restoration project, find out how to remove rusted floor pans and install new sheet metal on a 1963 Chevy Impala. Investing in the proper tools is essential in getting the job done right!