Dana 60, Driveline and Axles

In the 1950's and 60's, front engine dragsters were the fastest cars on the track. Then, they disappeared almost overnight. Here's the story of the rise, fall, and rebirth of the slingshot dragster.

Our hot rod expert takes you through his ford I beam axle setup. Follow as he sets up the front end on his split wishbone front suspension Model A.

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

The Speedway Motors Tech Team created a quick how-to on squaring the front axle of your open wheel race car.

In this Tech Tip, John responds to a customer request for our thoughts on an axle kit for his project.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Learn how to assemble the front axle of a sprint car. See what tools are needed for assembly including an angle finder gauge tool and king pin reamer.

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

Jennifer Helgoth is a painter and prolific builder who has amassed an fleet of Cadillacs, including this '60 Series 62 with one amazing paint job.

Drag racing changed a lot in the 60's, and Dick Landy was right in the middle of it all. This 64 Dodge was the first factory built 426 Hemi car to win a sanctioned drag race. How cool is that?