Ford Dana 60 Driveline and Axles

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

The Speedway Motors Tech Team created a quick how-to on squaring the front axle of your open wheel race car.

Learn how to assemble the front axle of a sprint car. See what tools are needed for assembly including an angle finder gauge tool and king pin reamer.

Drag racing changed a lot in the 60's, and Dick Landy was right in the middle of it all. This 64 Dodge was the first factory built 426 Hemi car to win a sanctioned drag race. How cool is that?

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

Jennifer Helgoth is a painter and prolific builder who has amassed an fleet of Cadillacs, including this '60 Series 62 with one amazing paint job.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Speedway Motors Product Manager Jeff K. talks about how to really make your engine bay stand out from the crowd with just a little patience, and some Speedway products.

Jeff's 1967 Chevelle project undergoes prep for a Dakota Digital Dash System. Keep a factory style dash with this wide sweep speedometer. Learn how to mount and wire modules for the gauge system, gear shift indicator, GPS speedo sender and auxiliary.