Dodge Dana 60 Driveline and Axles

Drag racing changed a lot in the 60's, and Dick Landy was right in the middle of it all. This 64 Dodge was the first factory built 426 Hemi car to win a sanctioned drag race. How cool is that?

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

In this Tech Tip, John responds to a customer request for our thoughts on an axle kit for his project.

Learn how to assemble the front axle of a sprint car. See what tools are needed for assembly including an angle finder gauge tool and king pin reamer.

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

Follow along as our Tech installs dropped spindels and performs a disc brake conversion on his '55 Sedan. He utilizes a metric brake conversion kit.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Jeff's 1967 Chevelle project undergoes prep for a Dakota Digital Dash System. Keep a factory style dash with this wide sweep speedometer. Learn how to mount and wire modules for the gauge system, gear shift indicator, GPS speedo sender and auxiliary.

In this restoration project, find out how to remove rusted floor pans and install new sheet metal on a 1963 Chevy Impala. Investing in the proper tools is essential in getting the job done right!