Chevy Chevelle Throttle Cables

Learn about performing an LS Swap in a 1972 Chevelle in this tech article. We'll discuss lessons learned from our Chevelle engine swap using a 500-horse 6.0.

This project consists of using welding cable to relocate a battery to the trunk of a 1967 Chevelle. Learn the benefits of using welding cable over normal battery cable and how line clamps are used to secure the wire to the frame rail.

We finally get to drive Project Chevelle after the big engine swap, and it's pretty awesome. Rowing through the gears with our new Tremec 5-speed isn't bad either!

A guide on how to install a floor replacement panel in the trunk of a 1967 Chevelle. Follow along to learn tips on fitting, cutting and welding sheet metal for a precise fit.

Next up, Jeff replaces the brake lines on his Chevelle. See how he uses a double flaring brake line tool by Titan Tools to create double flares. This tool is sure to make your life easier, and save some time!

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

Learn how to assemble a Gotta Show transmission cooler line kit for common GM transmissions. Jeff shares some helpful tips on measuring and cutting the braided stainless steel hose for an easier installation.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.

Jeff demonstrates the installation of front brake lines and hoses for his 1967 Chevelle. Learn how he uses a Titan mini-bender for all the tight bends this job required and an important tip on sealing pipe threads.