Carburetor Throttle Shafts

Do you have carbs sitting on the shelf waiting to be put on? Heath talks about the preparation and parts needed to install a set of Super 9-7 Carbs on his 1949 Flathead 8BA V8 Model A.

Learn about Dual Carb Linkage Setup. Follow along as an expert works through his fuel and throttle setup including part mounting and some modifications.

We look at the basics of performance carburetion and what you need to properly supply your street or race car with enough fuel in this buyer's guide

There's a right and wrong way to run a two-barrel carburetor on your vintage engine. Check out this guide about how to select the correct carburetor for your Flathead or vintage engine.

We get a lot of questions about steering parts. Steve talks about some of the steering basics.

Rebuilding a carburetor or renewing it is not as hard or intimidating as it looks. This article will guide you through the steps using a Holley rebuild kit.

Learn how to calculate your CFM with a formula to determine what the best carburetor size is for you. We also cover vacuum and mechanical secondaries.

In this Tech Tip, John offers up a couple solutions to a somewhat common problem of fuel expansion on the older vehicles.

We finally get to drive Project Chevelle after the big engine swap, and it's pretty awesome. Rowing through the gears with our new Tremec 5-speed isn't bad either!

Learn how to convert an engine using a Carbureted LS Conversion Kit, along with tips for a smooth install. Read more on the manifold and timing control module, which comes with an MSD ignition control box and wiring harness.