Rochester 2G Extended Secondary Carb Shaft
Extended throttle shaft for Rochester 2G carbs. This shaft is for a secondary carb in a tri-power three deuce setup with progressive linkage. Fits small base 2G and 2GC carbs from the mid '50s through approximately 1968 with throttle bore centers of 1.6".
- Brass construction
- 6-7/8" shaft (6.695")
- 5/16" diameter (.312")
- 6-32 x 1/4" socket head screw at the end
- 1.645" distance from factory linkage end to 1st butterfly screw hole center
- 11/16" butterfly screw hole centers (.685")
- Get FREE shipping when your order includes this item and exceeds $99! Ground shipping only in the contiguous US.
Q & A
Tim talks about Edmunds air cleaners and the history of Edmunds.
In this episode, Project Chevelle takes a big step in its muscle car transformation. It's out with the little old 307 and to the dyno with our new 383 from BluePrint Engines!
Tim talks about his favorite intake manifold, the Might Edelbrock X1.
We look at the basics of performance carburetion and what you need to properly supply your street or race car with enough fuel in this buyer's guide
In this Tech Tip, John offers up a couple solutions to a somewhat common problem of fuel expansion on the older vehicles.
Power brake boosters offer lower pedal effort and better braking characteristics, but which one is right for your hot rod, muscle car, or truck? We take the guesswork out of that question with our latest buyer's guide.
Tips and tricks to pull the most from your GM 602/604 platform.