Bricklin Ignition, Charging and Starting Parts

There are several aspects of a properly relocated battery installation. Our guide will help you ensure that your relocation goes smoothly.

Upgrading to electronic ignition is a huge improvement in performance, reliability, and lower maintenance that you can add to just about any engine your project may be running. Learn all about your electronic ignition choices in this buyer's guide.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Bringing an old Mopar back to life isn't always a breeze. Fortunately, MSD has come up with a solution for those outdated and unreliable points-type ignition systems. Find out how to install a MSD 8386 distributor and MSD 5531 spark plug wires

Speedway Tech Zach discusses the Pertronix Ignitor III conversion in his '55 Chevy.

Learn how to install spark plug wire terminal ends. Our step by step guide takes you through terminal end and boot installation with the use of a wire crimping tool.

Learn how to keep your starter cool using a heat shield. Read the steps and parts necessary for the installation.

Instructions on how to install a PerTronix Ignitor Kit in an old flathead distributor for a flathead V8.

Are your gauges reading erratically or does your car run out of power at high rpm? It may be the cause of a bad ground. Speedway Motors can show you how to diagnose and fix the problem in no time at all!

Are you a collector of automotive signs? This is a DIY project where you will learn how to convert a hardwired sign to a plug in. Jess M. explains each step to get the job done!