1970 Chevy Biscayne Accessory Drive

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

In this Tech Tip, John answers a customer concerns about adding additional drop to his 1960-1972 Chevy truck.

Josh takes the plunge into making some patch panels for his 50 Chevy pickup truck. See how he begins the installation process to get the truck back on the road.

Jeff's 1967 Chevelle project undergoes prep for a Dakota Digital Dash System. Keep a factory style dash with this wide sweep speedometer. Learn how to mount and wire modules for the gauge system, gear shift indicator, GPS speedo sender and auxiliary.

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

Jeff's Chevelle gets a dash overhaul. Follow along as he assembles the dash components and installs the A/C evaporator unit. This project highlights a refinished dash top, Astro vents and a new padded dash bumper.