1968 Ford E-300 Econoline T10 Parts

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Our project '68 C10 had some pretty rough sheet metal. In this episode, we go from a scary, rusty mess to a complete cab ready for bodywork.

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

We're kicking off the build of our custom 1968 Chevy C10 short bed Fleetside pickup truck with a video showing our humble starting point and a general guide on '60-'72 C10 truck features and history.

Jason Ankerson's 1965 Chevy C10 began its life as his high school beater. Over a decade of transformations, his first-gen C10 has become a modern reliable cruiser.