GM 32 and 1 Master Spline Yoke for TH400 Automatic Trans, 5-1/2 Inch
Universal Fit, 1310 Yoke U-Joint Series, 32 and 1 master Spline Count, 1.88" Shaft Diameter
These 32 and 1 master spline steel slip yokes are designed to work with TH-400 GM automatic transmissions and all Richmond Gear transmissions with a 32-spline output shaft. These are sold individually.
- 32 and 1 master spline
- Hardened steel construction
- For use in TH400, all Richmond Gear Transmissions w/ 32-spline output, and Super T-10 transmission
- Natural Finish
- Overall Length: 6.250 inches
- Accepts 1310 U-joints
- 5.5 in. from the U-joint center to the end of the yoke
- Sold Individually
( T400 ) - GM 32 spline yoke - Fits Turbo 400 , M22 Muncie, Borg Warner, Super T10 Warner, 4L80 Auto
- Get FREE shipping when your order includes this item and exceeds $99! Ground shipping only in the contiguous US.
Q & A
Speedway Motors employee Pat talks about how to measure your drive yoke for the proper universal joint.
Tim talks about our Ford banjo rear end open drive conversion kit.
In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.
In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.
Maintain your torque tubes with this quick tip for Speedway Motors.
We finally get to drive Project Chevelle after the big engine swap, and it's pretty awesome. Rowing through the gears with our new Tremec 5-speed isn't bad either!
Dalton discusses a few great safety features that we offer for our customers here at Speedway Motors . We have what you need to remain safe in your race car.