1968 Ford E-100 Econoline C4 Parts

In this Tech Tip, John answers a customer question about what would be needed to swap some additional power in place of his anemic 233c.i. Ford.

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

Our project '68 C10 had some pretty rough sheet metal. In this episode, we go from a scary, rusty mess to a complete cab ready for bodywork.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

Jeff walks through how to install an EFI filter for his fuel system. See how to assemble conversion fittings to accurately plumb the fuel lines and tips on fuel line routing.