1966 Chevy Impala Control Arm Assembly

Learn how replace lower and upper rear control arms. Read up on racer Steve's A-body control arm replacement and the bushings included kit he recommends.

Looking for a cost effective way to upgrade the front of your car? This article shows the steps to replace upper and lower stock control arms with tubular control arms for added suspension strength.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

Now that the control arms have been replaced on Jeff's 1967 Chevelle, the next step is to prep the control arms for use with coil-overs. See how to apply shock absorber mounts and the steps it takes to complete this conversion.

Save some weight by swapping in some upgraded control arms! Employee Steve L. reviews the 1970-81 Camaro Upper Control Arm.

Jeff demonstrates how to install a high quality rear trailing arm kit for his 1967 Chevelle. Learn more about the a-body rear suspension and its unique set of requirements. Find out how to eliminate wheel hop and promote “forward bite”.

Speedway Motors employee Pat O. talks about his decision to install a different steering column in his '64 Impala.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

Learn how to assemble a Gotta Show transmission cooler line kit for common GM transmissions. Jeff shares some helpful tips on measuring and cutting the braided stainless steel hose for an easier installation.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.