Front Engine Dragster Hammers

In the 1950's and 60's, front engine dragsters were the fastest cars on the track. Then, they disappeared almost overnight. Here's the story of the rise, fall, and rebirth of the slingshot dragster.

This beautiful veteran of the early 70's dragster wars was built by three brothers in a one-car garage in small town Iowa.

How to lower a C10 Chevy truck with lowering coil springs and install a front end rebuild kit. Upgrade your broken, rusty, or saggy suspension with our guide.

We finally get to drive Project Chevelle after the big engine swap, and it's pretty awesome. Rowing through the gears with our new Tremec 5-speed isn't bad either!

Learn how to assemble the front axle of a sprint car. See what tools are needed for assembly including an angle finder gauge tool and king pin reamer.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

In this budget build, a GM rear end is upgraded in order to hold 400+ HP. See how spherical bushings are replaced in a used 8.5” GM 10 bolt rear end.

Our Tech Expert installs an F1 steering box in his roadster to give the steering a traditional feeling. Follow his process from testing fit to welding.

Next on the to-do list was removing the rear axle assembly (aka the rear end).

See how to install 3" Ram Horn exhaust manifolds on a C/10 with a 406 engine. Learn some tips on welding steel tubing to a cast iron manifold and how they are modified to fit the truck.