Chevy Chevelle Garage Accessories Parts

Learn about performing an LS Swap in a 1972 Chevelle in this tech article. We'll discuss lessons learned from our Chevelle engine swap using a 500-horse 6.0.

See how Jeff installs Hedman mid-length headers to the big block in his '67 Chevelle. Learn about the modifications made to the steering shaft and the clamp on the lower steering column for a successful application.

Mike Earley fell in love with Chevelles when he was a little kid. Now he's lucky enough to own one of his own with a few unexpected tricks under the hood.

Get more details on Project Chevelle's 9-inch housing, third member, and tubular control arms installation.

Jeff K. does tires on everything. A good set of wheels and tires will finish a project better than any paint job can. So when his Chevelle needed a start, Jeff began right where he always does, with new shoes.

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.

Next up for Jeff's 1967 Chevelle is fuse block mounting and wiring. View this guide on how to remove old wiring to installing a new fuse block and 22 circuit wiring harness.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

Follow this guide on how to mount a single electric puller fan in a '66 - '67 Chevelle. Learn tips on taking measurements and installing a rubber spacer to prevent the fan from rubbing.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.