1969 Ford E-300 Econoline Auto Trans Kick Downs

Speedway Motors employee Pat O. is back to talk Ford Automatic OverDrive Kickdown brackets and kits.

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.

Learn how to lower a hot rod by modifying the axles and some history behind early hop ups. This project features a Ford axle with wishbones for a Model A.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Mike Earley fell in love with Chevelles when he was a little kid. Now he's lucky enough to own one of his own with a few unexpected tricks under the hood.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Darrian recently purchased a 302 Ford BluePrint Crate Engine for his 1962 Comet. Learn more as he walks you through what is included in the kit, it's out-of-the-box assembly and the performance metrics of the engine.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.