1968 Chevy K30 Engine Parts

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Now that our '68 C10 cab is straight and rust-free, it's time to bolt on the rest of the sheet metal, get it straight, and get it painted!

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!

Derek kicks off his 55 Chevy rebuild with a fresh small block.

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

Our project '68 C10 had some pretty rough sheet metal. In this episode, we go from a scary, rusty mess to a complete cab ready for bodywork.

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.