1968 Chevy Caprice Accessory Drive

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Follow along as we install a Pete Jackson Noisy Gear Drive on a Chevy 454. Learn about the installation process from Speedway Motors Street Tech Kevin.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

Josh takes the plunge into making some patch panels for his 50 Chevy pickup truck. See how he begins the installation process to get the truck back on the road.

In this Tech Tip, John answers a customer concerns about adding additional drop to his 1960-1972 Chevy truck.

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.

Next up, Jeff installs a custom exhaust system in his '67 Chevelle. See how he applies tailpipe tips and incorporates exhaust cutouts during the process.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.