1967 Cadillac DeVille Axles

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

With the new housing and brakes installed, Jeff chooses new wheels and tires for his 1967 Chevelle. See how he gets the perfect fit with enough clearance for brakes, coilovers and even 15" wheels.

Jeff's 1967 Chevelle project undergoes prep for a Dakota Digital Dash System. Keep a factory style dash with this wide sweep speedometer. Learn how to mount and wire modules for the gauge system, gear shift indicator, GPS speedo sender and auxiliary.

Next up, Jeff installs a custom exhaust system in his '67 Chevelle. See how he applies tailpipe tips and incorporates exhaust cutouts during the process.

After installing front brakes, Jeff is now ready for wheels and tires. See how a spacer is used to make his 15" wheels fit just right and a slick way to speed up the sanding and polishing process of the wheel dust caps.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

See the final steps of installing a custom exhaust system on a '67 Chevelle. Learn some tips on how to offset and install the exhaust U bend tailpipe.

Jeff chooses Redline Radial Tires and black powder-coated steel wheels for his 1967 Chevelle. See how he installs the tires with some helpful tips along the way.