1966 Chevy G10 Van Driveline and Axles

Blown 1966 Chevy C10 built for cruising.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

From a mild leveling to slammed and “in the weeds” there are several options to lowering a C10. We discuss the options in our ’67-’72 C10 lowering guide.

Sometimes, a simple paint job can cause a project to spiral out of control. In the case of Steve's '66 Chevelle, it came out way better than anyone expected.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Jason Ankerson's 1965 Chevy C10 began its life as his high school beater. Over a decade of transformations, his first-gen C10 has become a modern reliable cruiser.

Looking for a driveshaft for your 67-72 C10? Our custom-length driveshaft kits make it a breeze to get the perfect 67-72 C10 driveshaft length. Follow along as we show how to measure and install a C10 one piece driveshaft.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Jeff demonstrates the installation of front brake lines and hoses for his 1967 Chevelle. Learn how he uses a Titan mini-bender for all the tight bends this job required and an important tip on sealing pipe threads.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.