Studebaker Lark Pipe Weld Bung Fittings

Hooker headers are installed in a 1967 Pontiac Firebird for increased power and a boost in performance. See how to work through fitment of the steering box, clutch Z bar and starter.

In preparation to transplant a 430hp 383 stroker into Project Chevelle, Zach R. made up a set of plug wires for the car. To keep it nice and tidy they needed to be routed just right, be the perfect length and not distract from the engine!

Dick from Koul Tools shares a tip on how to properly seat the AN fittings using the Koul Tools device.

We all need a little help from time to time. In this case, we had a grill shell on a 1946 Chevrolet Truck that could use some stiffening. Ride along as Heath installs support rods and rod brackets.

Learn how to repair an oil line leak using steel braided hose and AN fittings. See how to cut the hose, measure angles, apply fittings and install fuel lines back into your car.

So many brake kits. So many options. Take a breath and click here.

Follow this visual guide on installing spacer rings for Buick style finned brake drums to help center the drum on the hub. Learn some tips on using old and new parts for the installation.

A guide to choosing the right camshaft for your engine. See how to install a new LSR roller camshaft while upgrading valve springs and rocker trunnions.

The LS swap is no doubt still going strong, but if you’re planning to run an automatic behind your 4.8, 5.3, or 6.0L LS-powered ride, you’ll need to pay attention to a few items we discuss in this buyer’s guide.

Learn how to install spark plug wire terminal ends. Our step by step guide takes you through terminal end and boot installation with the use of a wire crimping tool.