Chevy Stovebolt Street Parts

Take a look at a few of the rare and wonderful Chevy engines in the Museum of American Speed!

Learn how to assemble a Gotta Show transmission cooler line kit for common GM transmissions. Jeff shares some helpful tips on measuring and cutting the braided stainless steel hose for an easier installation.

Not only is Greg Turner's '56 a great driver, it's full of great family memories. Built in the home garage by Greg and his sons, this clean Chevy has covered a lot of miles.

After getting the control arms and drop spindles installed last time, we are dying to see what it looks like on the ground. Today we are working with the Speedway Deluxe Disc Brake Kit. Josh and Joe are on a roll!

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

Sometimes, a simple paint job can cause a project to spiral out of control. In the case of Steve's '66 Chevelle, it came out way better than anyone expected.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

Installation guide for Speedway Motors 9" Bolt-In Rear End Axle on a 1967 Chevelle. This housing allows the use of any coil-over conversion made to work with a factory housing. Learn how to fasten the third member into the housing with studs.

Next up for Jeff's 1967 Chevelle is fuse block mounting and wiring. View this guide on how to remove old wiring to installing a new fuse block and 22 circuit wiring harness.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.