Ford Dana 70 Driveline and Axles

Our hot rod expert takes you through his ford I beam axle setup. Follow as he sets up the front end on his split wishbone front suspension Model A.

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Jarry and Ryan Givens are father and son, and this pair of Novas proves the apple doesn't fall far from the tree!

We will show you the differences among traditional I-beam and tube axles and suspension designs used on hot rods; the differences between cross and traditional steering, measuring for springs, what spindles to choose, and much more.

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

Learn how to assemble the front axle of a sprint car. See what tools are needed for assembly including an angle finder gauge tool and king pin reamer.

In this Tech Tip, John helps to sort out some fresh suspension for a customer’s ’70 Nova.

Jeff's 1967 Chevelle project undergoes prep for a Dakota Digital Dash System. Keep a factory style dash with this wide sweep speedometer. Learn how to mount and wire modules for the gauge system, gear shift indicator, GPS speedo sender and auxiliary.

Dan's Chevelle started out as a Christmas present in 1993. It's been with him ever since, for better and for worse. Here's the story in Dan's words.