Accel 1967 Ford Bronco Parts

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

Jeff demonstrates the installation of front brake lines and hoses for his 1967 Chevelle. Learn how he uses a Titan mini-bender for all the tight bends this job required and an important tip on sealing pipe threads.

Jeff converts his 1967 Chevelle manual brake system to power by installing a Delco booster kit. Learn how to make the master cylinder more resistant to brake fluid and a few tips for an easy install.

Jeff walks through how to install an EFI filter for his fuel system. See how to assemble conversion fittings to accurately plumb the fuel lines and tips on fuel line routing.

Jeff tackles the task of installing a Big Block Engine into his 1967 Chevelle. Read about the hardships he faced and some of the tricks he learned to make this installation run smoothly.

A step by step on how to install an EFI Fuel Tank kit in a 1967 Chevelle. Learn the benefits of using this kit including expanded fuel capacity and a 24 gallon tank.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.