1964 Buick Special 4L70E Chassis and Suspension Parts

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

Speedway Motors employee Pat O. talks about his decision to install a different steering column in his '64 Impala.

Jeff tackles the task of installing a Big Block Engine into his 1967 Chevelle. Read about the hardships he faced and some of the tricks he learned to make this installation run smoothly.

See the final steps of installing a custom exhaust system on a '67 Chevelle. Learn some tips on how to offset and install the exhaust U bend tailpipe.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Follow along as Jeff installs an early 700R4 transmission for the big block in his 1967 Chevelle. See how this unit is upgraded and converted to a later 30 spline style.

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

Next up, Jeff installs a custom exhaust system in his '67 Chevelle. See how he applies tailpipe tips and incorporates exhaust cutouts during the process.

After installing front brakes, Jeff is now ready for wheels and tires. See how a spacer is used to make his 15" wheels fit just right and a slick way to speed up the sanding and polishing process of the wheel dust caps.