Chevy Vega 4L60E Driveline and Axles

A real-world guide to 4L60 transmission specs, strength, and swap tips.

Follow along as our Tech installs dropped spindels and performs a disc brake conversion on his '55 Sedan. He utilizes a metric brake conversion kit.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

After installing front brakes, Jeff is now ready for wheels and tires. See how a spacer is used to make his 15" wheels fit just right and a slick way to speed up the sanding and polishing process of the wheel dust caps.

Follow along as we install a Pete Jackson Noisy Gear Drive on a Chevy 454. Learn about the installation process from Speedway Motors Street Tech Kevin.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

Not only is Greg Turner's '56 a great driver, it's full of great family memories. Built in the home garage by Greg and his sons, this clean Chevy has covered a lot of miles.

Derek kicks off his 55 Chevy rebuild with a fresh small block.

Learn how Zach replaces a transmission and breakaway converter in his 55 Chevy, with some helpful tips along the way.