Chevy DR C6 Driveline and Axles

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Axle / Clevis / Bracket / Radius Rod Assembly

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Looking for a driveshaft for your 67-72 C10? Our custom-length driveshaft kits make it a breeze to get the perfect 67-72 C10 driveshaft length. Follow along as we show how to measure and install a C10 one piece driveshaft.

After getting the control arms and drop spindles installed last time, we are dying to see what it looks like on the ground. Today we are working with the Speedway Deluxe Disc Brake Kit. Josh and Joe are on a roll!

Jason Ankerson's 1965 Chevy C10 began its life as his high school beater. Over a decade of transformations, his first-gen C10 has become a modern reliable cruiser.

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.