Chevy Chevelle Fuse Strips

Next up for Jeff's 1967 Chevelle is fuse block mounting and wiring. View this guide on how to remove old wiring to installing a new fuse block and 22 circuit wiring harness.

Jeff's Chevelle gets a dash overhaul. Follow along as he assembles the dash components and installs the A/C evaporator unit. This project highlights a refinished dash top, Astro vents and a new padded dash bumper.

Learn how to equip your car with A/C by installing the Vintage Air GenIV SureFit Complete Kit. Jeff installs this kit in his 1967 Chevelle while making some vent modifications to enhance the look and direct air better.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

A guide on how to install a floor replacement panel in the trunk of a 1967 Chevelle. Follow along to learn tips on fitting, cutting and welding sheet metal for a precise fit.

Jeff demonstrates the installation of front brake lines and hoses for his 1967 Chevelle. Learn how he uses a Titan mini-bender for all the tight bends this job required and an important tip on sealing pipe threads.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.