Cadillac DeVille C6 Driveline and Axles

Jennifer Helgoth is a painter and prolific builder who has amassed an fleet of Cadillacs, including this '60 Series 62 with one amazing paint job.

We will show you the differences among traditional I-beam and tube axles and suspension designs used on hot rods; the differences between cross and traditional steering, measuring for springs, what spindles to choose, and much more.

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Learn how to assemble the front axle of a sprint car. See what tools are needed for assembly including an angle finder gauge tool and king pin reamer.

After installing front brakes, Jeff is now ready for wheels and tires. See how a spacer is used to make his 15" wheels fit just right and a slick way to speed up the sanding and polishing process of the wheel dust caps.

Axle / Clevis / Bracket / Radius Rod Assembly

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.