1968 Plymouth Roadrunner Engine Parts

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

The dyno at the Speedway Motors Racing Engine shop is always humming. We set up a camera in the cell to catch a few of the engines that have passed through the door recently.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Follow this restoration guide as Josh breathes new life back into his Pontiac engine.

Watch Zach build our 383 engine for the 1932 Roadster. Zach and Joe breathe new life into our 383 by adding a Holley 750 4 Barrel Carburetor and Dyers 4-71 blower.