1967 Ford Bronco Shift Linkage

Jeff tackles the installation of the Lokar Muscle Car Shifter inside of a factory stick-shift floor pan section. This product won a "Best Interior Product" Award at the SEMA show in 2016.

Follow along as Jeff installs an early 700R4 transmission for the big block in his 1967 Chevelle. See how this unit is upgraded and converted to a later 30 spline style.

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

Jeff converts his 1967 Chevelle manual brake system to power by installing a Delco booster kit. Learn how to make the master cylinder more resistant to brake fluid and a few tips for an easy install.

Learn about the G Force crossmember and how the symmetrical product design makes for a smooth installation on Jeff's 1967 Chevelle.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

Jeff demonstrates the installation of front brake lines and hoses for his 1967 Chevelle. Learn how he uses a Titan mini-bender for all the tight bends this job required and an important tip on sealing pipe threads.