1967 Chevy K20 Frame

Follow this guide on how to install a splined sway bar for GM A-body applications. See the installation process on a '68 Chevelle frame using stock control arms and factory chassis bolt and pad locations.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

Jeff converts his 1967 Chevelle manual brake system to power by installing a Delco booster kit. Learn how to make the master cylinder more resistant to brake fluid and a few tips for an easy install.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Learn about the G Force crossmember and how the symmetrical product design makes for a smooth installation on Jeff's 1967 Chevelle.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

With the new housing and brakes installed, Jeff chooses new wheels and tires for his 1967 Chevelle. See how he gets the perfect fit with enough clearance for brakes, coilovers and even 15" wheels.