1966 Studebaker Commander T56 Driveline and Axles

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Sometimes, a simple paint job can cause a project to spiral out of control. In the case of Steve's '66 Chevelle, it came out way better than anyone expected.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

In this Tech Tip, John responds to a customer request for our recommendations on brake kits for his ’56 F100.

Not only is Greg Turner's '56 a great driver, it's full of great family memories. Built in the home garage by Greg and his sons, this clean Chevy has covered a lot of miles.

Jeff demonstrates the installation of front brake lines and hoses for his 1967 Chevelle. Learn how he uses a Titan mini-bender for all the tight bends this job required and an important tip on sealing pipe threads.

Learn how to assemble a Gotta Show transmission cooler line kit for common GM transmissions. Jeff shares some helpful tips on measuring and cutting the braided stainless steel hose for an easier installation.

Next up, Jeff replaces the brake lines on his Chevelle. See how he uses a double flaring brake line tool by Titan Tools to create double flares. This tool is sure to make your life easier, and save some time!