1966 Chevy C20 Accessory Drive

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Follow along as we install a Pete Jackson Noisy Gear Drive on a Chevy 454. Learn about the installation process from Speedway Motors Street Tech Kevin.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Read how to install rear drop spring to lower a 1969 C10 pickup. Follow these steps for a smooth installation.

Follow along as Jeff installs Mr. Gasket aluminum finned valve covers and gaskets to his iron-head engine. Learn how to prep the covers for a fresh coat of engine paint!

In this Tech Tip, John answers a customer concerns about adding additional drop to his 1960-1972 Chevy truck.

Sometimes, a simple paint job can cause a project to spiral out of control. In the case of Steve's '66 Chevelle, it came out way better than anyone expected.

Josh takes the plunge into making some patch panels for his 50 Chevy pickup truck. See how he begins the installation process to get the truck back on the road.

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.