Studebaker 2R10 Adhesives and Tape

HushMat “Easy to Install – No Prep” Adhesion test WD40 on Chop Cut Rebuild show demonstrates the superior adhesive quality of HushMat sound deadening & thermal insulation material.

Many sanctioning bodies now require mud covers to be bolted to the wheel and the mounting tabs to be integral or welded to the wheel. This article explains how to properly bolt on mud covers and the tools required to do so.

Read how to install rear drop spring to lower a 1969 C10 pickup. Follow these steps for a smooth installation.

Testing a 2 or 3 wire speed sensor sounds difficult, but these videos show that it actually is quite easy!

Part II of HushMat's video demonstrations on installation tips and tricks to assist you with installation.

Hooker headers are installed in a 1967 Pontiac Firebird for increased power and a boost in performance. See how to work through fitment of the steering box, clutch Z bar and starter.

In this video, Joe and Darrian discuss and demonstrate how to properly set up and use the Speedway Tubing Notcher. It’s the perfect tool for fabricators and hobbyists alike! Use it to make headers, custom chassis, roll cages, or anything in between.

Here are some suggestions about which tools can make your life easier while building body panels.

Broken exhaust studs are a common problem. This article describes what you need and how to remove a broken stud from an exhaust manifold. Learn how simple it is to remove broken or stubborn studs with a Titan Tools stud extractor tool.

Hose & Fitting