GMC 1000 C6 Driveline and Axles

Our hot rod expert takes you through his ford I beam axle setup. Follow as he sets up the front end on his split wishbone front suspension Model A.

We will show you the differences among traditional I-beam and tube axles and suspension designs used on hot rods; the differences between cross and traditional steering, measuring for springs, what spindles to choose, and much more.

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

Read up on GM 10 bolt ring and pinion installation instructions. Follow along as our employee Zach installs a GM 10 bolt rebuild kit from Motive Gear.

The Speedway Motors Tech Team created a quick how-to on squaring the front axle of your open wheel race car.

Today on our 410 sprint car, the guys are assembling the front axle. The process can be a bit messy, but the finished product is so worth it!

Follow along as we give our C10 truck project a much needed dose of suspension travel with a bolt-on C-notch kit.

Learn how to assemble the front axle of a sprint car. See what tools are needed for assembly including an angle finder gauge tool and king pin reamer.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.