Front Engine Dragster Microfiber Towels

This beautiful veteran of the early 70's dragster wars was built by three brothers in a one-car garage in small town Iowa.

Preventative maintenance is crucial for hot rods. In this article, Jess shows you how to place a front wheel cylinder on an early Ford.

Read how to square the front axle in your Micro Sprint car. Learn about the importance of squaring, measurements to use, and important steps to follow.

Tim M. has tried to stay true to the vintage route, but sometimes, exceptions must be made. For example, the original oiling system's paper element and canister are functional, but an upgraded system will be more reliable.

Cleaning fuel injector nozzels is a must in your car maintenance regimen. Learn the steps on how to properly disconnect fuel lines and check the barrel valve.

We will show you the differences among traditional I-beam and tube axles and suspension designs used on hot rods; the differences between cross and traditional steering, measuring for springs, what spindles to choose, and much more.

It is most certainly an important procedure and should be part of a weekly maintenance routine.

Our hot rod expert takes you through his ford I beam axle setup. Follow as he sets up the front end on his split wishbone front suspension Model A.

Unbox new apparel from Speedway Motors

Here are some suggestions about which tools can make your life easier while building body panels.