Chevy DP 4L60E Driveline and Axles

A real-world guide to 4L60 transmission specs, strength, and swap tips.

Follow along as our Tech installs dropped spindels and performs a disc brake conversion on his '55 Sedan. He utilizes a metric brake conversion kit.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

After installing front brakes, Jeff is now ready for wheels and tires. See how a spacer is used to make his 15" wheels fit just right and a slick way to speed up the sanding and polishing process of the wheel dust caps.

Follow along as we install a Pete Jackson Noisy Gear Drive on a Chevy 454. Learn about the installation process from Speedway Motors Street Tech Kevin.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Drag racing changed a lot in the 60's, and Dick Landy was right in the middle of it all. This 64 Dodge was the first factory built 426 Hemi car to win a sanctioned drag race. How cool is that?

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

Jeff's 1967 Chevelle project undergoes prep for a Dakota Digital Dash System. Keep a factory style dash with this wide sweep speedometer. Learn how to mount and wire modules for the gauge system, gear shift indicator, GPS speedo sender and auxiliary.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.