Chevy Chevelle Valve Locks

Follow along as Jeff installs Mr. Gasket aluminum finned valve covers and gaskets to his iron-head engine. Learn how to prep the covers for a fresh coat of engine paint!

Follow along as we install a Pete Jackson Noisy Gear Drive on a Chevy 454. Learn about the installation process from Speedway Motors Street Tech Kevin.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Learn how to equip your car with A/C by installing the Vintage Air GenIV SureFit Complete Kit. Jeff installs this kit in his 1967 Chevelle while making some vent modifications to enhance the look and direct air better.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

A guide on how to install a floor replacement panel in the trunk of a 1967 Chevelle. Follow along to learn tips on fitting, cutting and welding sheet metal for a precise fit.

Learn how to successfully upgrade the cooling system for a 400 small block Chevy. Read tips for installing a water pump and auxiliary coolant lines using fittings and fuel hoses.

Want some brakes for your 1949-1954 Chevy spindles? Click here!

Check out these 1949- '54 Chevy Spindles Specs!