Chevy 3F C6 Driveline and Axles

Dive into some of the history and unique differences between Ford and Chevy spindles for solid front axles and what will perform best on your hot rod.

We will show you the differences among traditional I-beam and tube axles and suspension designs used on hot rods; the differences between cross and traditional steering, measuring for springs, what spindles to choose, and much more.

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Axle / Clevis / Bracket / Radius Rod Assembly

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

Jeff demonstrates the installation of front brake lines and hoses for his 1967 Chevelle. Learn how he uses a Titan mini-bender for all the tight bends this job required and an important tip on sealing pipe threads.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.