1966 Chevy G10 Van Ignition, Charging and Starting Parts

Bringing an old Mopar back to life isn't always a breeze. Fortunately, MSD has come up with a solution for those outdated and unreliable points-type ignition systems. Find out how to install a MSD 8386 distributor and MSD 5531 spark plug wires

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Learn about the wiring of GM HEI Ignition Distributors with our diagrams and guide. Ensure you are getting the best performance out of your ignition system.

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.

Follow this detailed guide on installing a FiTech EFI system in a '67 Chevelle. Learn helpful tips along the way including how to route the blue trigger wire away from the coil and ignition system.

Blown 1966 Chevy C10 built for cruising.

Sometimes, a simple paint job can cause a project to spiral out of control. In the case of Steve's '66 Chevelle, it came out way better than anyone expected.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

Not only is Greg Turner's '56 a great driver, it's full of great family memories. Built in the home garage by Greg and his sons, this clean Chevy has covered a lot of miles.

Jeff tackles the task of installing a Big Block Engine into his 1967 Chevelle. Read about the hardships he faced and some of the tricks he learned to make this installation run smoothly.