1966 Chevy C20 AOD Driveline and Axles

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Sometimes, a simple paint job can cause a project to spiral out of control. In the case of Steve's '66 Chevelle, it came out way better than anyone expected.

Follow this guide on how to install a splined sway bar for GM A-body applications. See the installation process on a '68 Chevelle frame using stock control arms and factory chassis bolt and pad locations.

Jeff chooses Redline Radial Tires and black powder-coated steel wheels for his 1967 Chevelle. See how he installs the tires with some helpful tips along the way.

Follow along as Jeff chooses redline radial tires and steel wheels to get the perfect fit for his Chevelle. Learn how redlines are added to a set of Real Rodder mags for a consistent 60's theme.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.