1966 Chevy Biscayne Steering Linkage

So you're just about finished on your front end and it's time to install the steering linkage! Speedway can show you how to properly measure for a Tie-rod or Drag-link to make sure steering is easy on your rod.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

Learn about the G Force crossmember and how the symmetrical product design makes for a smooth installation on Jeff's 1967 Chevelle.

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

Jeff demonstrates the installation of front brake lines and hoses for his 1967 Chevelle. Learn how he uses a Titan mini-bender for all the tight bends this job required and an important tip on sealing pipe threads.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!