What vehicle did they design these for??
Let me start by saying I am a mechanical engineer by day, and a weekend hotrodder. I have built quite a few cars from the ground up, including complete chassis and suspension fabrication. I'm not scared to modify something to make it work. That being said, these are the worst fitting headers I have ever bought for any application. They are installed on a 235 in a '52 Styleline deluxe. If you plan on using these headers in a similar chassis, be prepared to fabricate new throttle linkage, notch your motor mount, and cut off the emergency brake mount to make these work. The stock hardware will work for bolting them to the head, but you have to modify the hold down clamps to get them to sit flush. Actually installing the headers takes less than an hour, but making all of the car's parts fit around them will take you quite a bit of tinkering. If you do not have access to a welder, line up a friend who does before you take your car apart. The sound of a split six, however, is absolutely amazing. The tubular headers have more of a metallic "ring" to them than the cast fentons, which I love. I am running them into 2" straight pipes with no mufflers and it's nothing short of musical. I haven't turned the stereo on since I installed the headers. Freeing up the exhaust on these sixes really helps them power-wise. Especially with multiple carbs and a Fenton or Offy intake. My car is no drag racer, but it's significantly more fun to drive now. All in all, I would recommend the repop fentons over these. Unless, of course, you want that metallic ring like I did, then these can't be beat.