Studebaker 2R10 LS Chevy Control Modules

Learn about performing an LS Swap in a 1972 Chevelle in this tech article. We'll discuss lessons learned from our Chevelle engine swap using a 500-horse 6.0.

Heath P. tells his story on how the passion for 'hot rodding' was instilled in him by his grandfather. From driving tractors on their family farm to becoming a Ford family, you are in for a good read.

Looking to update that '67-'72 C10 truck with an LS swap? These motors mounts and transmission crossmember kit will make that modern powerplant and transmission fit like they came that way from the factory!

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

GM’s 10-bolt rear axle has been around since the 1960s, here’s how to determine if your junkyard find is worth taking home

In this Tech Tip, John responds to a customer question about tubular control arms.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

How to lower a C10 Chevy truck with lowering coil springs and install a front end rebuild kit. Upgrade your broken, rusty, or saggy suspension with our guide.

Looking for a driveshaft for your 67-72 C10? Our custom-length driveshaft kits make it a breeze to get the perfect 67-72 C10 driveshaft length. Follow along as we show how to measure and install a C10 one piece driveshaft.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.