New Vintage USA Switch Mounting Panels

Speedway Motors announced today a list of new products that will be debuted Aug. 5-8 at National Street Rod Association’s (NSRA) 52nd Annual Street Rod Nationals in Louisville, Ky.

Looking to replace a turn signal switch in your street rod, rat rod or muscle car? Kevin explains the install process in his 1954 Belair, which you can apply to your own build.

Learn a few tips on how to properly mount Modified bodies and some products that will help get your race car body fabrication job done!

In this restoration project, find out how to remove rusted floor pans and install new sheet metal on a 1963 Chevy Impala. Investing in the proper tools is essential in getting the job done right!

Speedway Motors employee Pat O. talks about his decision to install a different steering column in his '64 Impala.

Tim talks about the process of upgrading the factory hubs on his 1929 Roadster project with new manufacture units courtesy of Speedway Motors.

Jeff K. does tires on everything. A good set of wheels and tires will finish a project better than any paint job can. So when his Chevelle needed a start, Jeff began right where he always does, with new shoes.

Wiring a car may seem like a daunting process, but Jess explains the steps to successfully wire the ignition switch, headlight switch, and the dash gauges.

Check out a couple of tips on how to install a new clutch.

Kevin W. walks through each step of installing a new alternator bracket on a 454 Big Block Chevy.